Making comic book ornaments

You find old (worn, more like it) comic book pages, take a nice pic out and turn it into an ornament. What could be cooler than that?

I found this idea with excerpt below, at GeekCrafts where you can read more in detail.


Making comic book ornaments

My craft is comic book ornaments, as seen in the examples below. I figured it was an easy introduction to decoupage, but infinitely customizable to whatever comic brunchettes might favor, along with whatever ornament base they might choose.

Comic Book Ornaments by Angie Pedersen

Basic instructions:

  1. Select ornaments in shapes that will showcase an identifiable amount of comic art, in shapes that should be easy to cut out.
  2. Page through your comics for images that will fit your ornament. TIP: If the image you want is too big, you can scan it and resize to fit your ornament. That’s what I did for the Dr. Horrible cube above.
  3. Place the ornament on top of the comic page and trace around it. Cut out with scissors.
  4. Brush Mod Podge (I used matte, but glossy would also work) on the ornament and position the comic cut out on top. Smooth out any wrinkles (a brayer helps here).
  5. Brush a coat of Mod Podge over the surface of the comic image to seal.
  6. Optional: embellish the edges of the ornament with decorative washi tape (see Buffy example above) or acrylic paint (see TARDIS example above). For the Dr. Horrible cube, I colored the top of it with a bronze metallic Sharpie (top not shown).

Related posts

*

*

Top